Plaster wall repair
Hairline and deep cracks, loose or bulging plaster, and blending old plaster with later drywall patches.
See how we handle itHome / Hole and dent repair
A hole is the easiest wall problem to understand and one of the easiest to botch. Here is how we make one go away.
Stage 1
Every house has one. A bedroom door swings open on a Saturday morning, the knob meets the wall, and a round crater appears in the drywall with a ring of crumbs around it. Nobody means it. A hallway stays narrow and the door keeps swinging, and a year later there are two craters.
In an older Altoona house the story has a twist. If the wall is plaster, a knob strike can crack a spiderweb around the dent and leave the surface sound underneath. If a room was reworked in the last few decades, the same knob can punch straight through thin drywall into the hollow beyond. The repair begins with working out which wall you have.

Stage 2
We tap around the damage to find how far the weak area runs. A dent in plaster is often shallow but surrounded by loose or hairline-cracked surface, and a patch laid over that will fail at the edge. In drywall we check the paper face, the gypsum behind it and what is in the cavity, because wiring or pipe near a hole changes the method.
Small holes up to about the size of a doorknob crater get a self-adhesive mesh or a backing plate, then thin coats of compound. Bigger holes get a cut-out and a drywall plug screwed to fresh backing. Plaster dents are filled with setting compound that is harder than ordinary joint compound, so the patch matches the density of the wall around it.
Stage 3
The median house in Altoona dates from around the mid-1940s by Census-derived estimates, and the older rowhouse blocks near downtown often have narrow stair halls where doors swing into walls. Plaster walls from that era are harder than modern drywall and do not forgive a quick fill.
Many owners here live in the house they repair, since roughly 64 percent of Altoona homes are owner-occupied. That means a patch is something you will look at every morning. We feather wide and prime the area so paint will not flash, which is when a patch shows as a dull or shiny spot against the finished wall.
Stage 4
A hole that is wider than your hand, any opening with a soft or crumbling edge, and anything with a stain or damp smell around it needs a closer look. So does a hole in a bathroom or kitchen wall, where a dent can hide a cracked tile backer or a seep behind the surface.
An old anchor hole that keeps spitting out the plug has lost its grip because the material around it has crumbled. We cut that back to sound surface instead of pushing a fresh plug into a failing socket.
Stage 5
Clear the wall and a few feet around it. Take one photo from across the room and one close up, with a coin beside the hole for scale. Tell us if you know when it happened and whether the wall is plaster or drywall, and note any switch, outlet or pipe nearby.
If a picture frame is going back in the same place later, mention it. We can set a solid anchor point in the repair so the next hook has something to bite.
Questions
On smooth walls, yes, by feathering and priming. On textured plaster or sand-finish walls we recreate the surface pattern as closely as the material allows and tell you honestly how close it will come before paint.
A properly feathered patch should not, as long as the primer is applied and the new paint is blended to a natural break in the wall. We prime so the repair absorbs paint like the surrounding surface.
Yes. Those are among the most common calls. We also add a stop suggestion if the knob is the culprit.
If it bothers you every time you pass it, yes. Several small holes in one room can be done in a single visit.
Hairline and deep cracks, loose or bulging plaster, and blending old plaster with later drywall patches.
See how we handle itClosing up walls and ceilings opened for wiring, plumbing, ductwork or windows so the repair disappears.
See how we handle itRoof leaks, winter ice-related leaks and bathroom leaks from above. We cut out damaged material and rebuild.
See how we handle itRecurring cracks over doors and windows, popped fasteners in later drywall additions, and dented or cracked corner bead.
See how we handle itPhotos and a sentence about what happened are enough to start. We will ring or text back.