Hole and dent repair
Doorknob holes, old anchor and fixture holes, furniture dents. Patched flush and feathered so the spot cannot be found.
See how we handle itHome / Patching after upgrades
When the trades go home, the walls are still open. Closing them well is what decides whether the work looks finished.
Stage 1
A van pulls away from the curb and the new circuits are live, but the second-floor hallway has a row of rough openings cut in it like windows in a ship. The plaster edges are ragged, dust is on the stair, and somewhere a roll of tape is waiting for someone else to decide what happens next.
That someone is us. We come after the rough work is signed off and before the painter, and we close the openings so cleanly that the next visitor never learns they were there.

Stage 2
With a median build year around the mid-1940s by Census-derived estimates, a great many Altoona houses still carry their original wiring and plumbing, and owners here, about 64 percent of them according to Census QuickFacts, tend to upgrade them rather than move.
In the older rowhouse blocks, runs of wire and pipe frequently pass through party walls and tight stair halls, and the openings are cut where the trade could reach, not where a wall looks tidy. The result is a patchwork that needs one hand to unify it.
The city was founded in 1849 for the railroad, and houses built for workers in that era were not framed with modern chases for cable in mind. Retrofit work cuts into plaster and lath, and the edges of those cuts are rarely straight.
Stage 3
The new surface has to be flush with the old. Old plaster is often three-quarters of an inch thick, and drywall comes in thinner sheets, so we build up the difference with backing and shims rather than leaving a recess you can see under raking light.
Joints have to be taped so they do not crack along the patch edge. Where a patch spans from plaster onto a stud or across a corner, we reinforce it. And where a ceiling was opened for a duct or a recessed fixture, we clear the dust, set solid backing, and rebuild to the original plane.
Then comes texture. Smooth, sand-finish, knockdown and hand-troweled walls all need different final steps, and we match the pattern we find as closely as the material allows.
Stage 4
New windows leave a fringe of damaged plaster around the frame, and the returns, the sides of the opening, often need rebuilding. A new furnace or air-handler run might open a ceiling in three places and a closet wall in a fourth. A plumber chasing a drain stack can take out a vertical strip the height of a room.
Whatever the opening, our method is the same: clean edges, solid backing, thin coats, sanding between each, and a primer coat so that paint absorbs evenly across old and new.
Stage 5
The best time to tell us is before the walls are opened. Ask the electrician or plumber how many openings, roughly where, and when the inspection is. We will schedule behind them and may suggest cutting in straight lines, since a rectangle is easier to patch than a ragged hole. If the work is already done, send us pictures of each opening; a hallway of patches can be done in one visit.
Questions
Yes. Tell us the sequence and we will come in after inspections and before painters.
Not if they are built flush, taped, feathered wide and primed. Skipping the priming is the usual reason they flash.
Ceiling patches need extra backing and careful sanding because raking light from windows exposes small imperfections.
Yes, including the returns and any plaster damage near the frame.
Doorknob holes, old anchor and fixture holes, furniture dents. Patched flush and feathered so the spot cannot be found.
See how we handle itHairline and deep cracks, loose or bulging plaster, and blending old plaster with later drywall patches.
See how we handle itRoof leaks, winter ice-related leaks and bathroom leaks from above. We cut out damaged material and rebuild.
See how we handle itRecurring cracks over doors and windows, popped fasteners in later drywall additions, and dented or cracked corner bead.
See how we handle itPhotos and a sentence about what happened are enough to start. We will ring or text back.